Might I add that this device was designed for the Rev 2 version of Innovatek’s flow meter; later versions will work, but Rev 2 will provide the best accuracy since it has a jewel bearing.

   The device also has an emergency shut down feature in event of an error. There are also spots for a power LED and error LED. The I-Bus channels on the Micro allow it to connect to the Fan-O-Matic Pro which allows you to program the values for the Micro.

Layout


Setting 1 = Air Cooling / Setting 2 = Water Cooling / Setting 3 = Set By The Fan-O-Matic Pro

 

Fan Connection

• RPM's is controlled by the micro controller

• StartBoost (1sec with higher voltage to start the fan spinning)

• Fan channel can handle up to 12W

• Analog voltage regulation, no PWM disturbances (quieter)

• Power / Electrical short protection

• Preconfigured rule-curves for fan control

• Adjustable fan deactivation (switches the fan off if not required)

Temperature Sensor

• Measuring range of 10 to 100 (degrees celcius)

• The flat sensor can be attached almost anywhere

• If the set limit is exceeded the following alarms are possible: Optional error LED or the computer can completly shut off

• The Innovatek inline water temperature sensor will also work

Other

• Can be configured to work with the Innovatek flow-meter rev. 2

• The desired alarm temperature can be manually adjusted on the device

• Free switch connection which will allow the PC to shut down in the event of an alarm (optional)

• Connection of a power and error LED (direct connection of LED is possible)

• I-Bus system to allow it to connect to the Fan-O-Matic Pro