Best viewed with IE 4.0 or later, 1024 X 768.
The whole operation shouldn't take you more than 5
minutes. You can see that some of the plastic has melted due to the
heat generated by the wheel. Just use the small file to remove them
and file the hole to the correct size.
First hole done
Click to enlarge |
Both holes completed
Click to enlarge |
After filing off to size
Click to enlarge
Next, test the LCD panel's fit to the holes. It should
not be too tight or too loose, just nice for the clips at the back
of the LCD panel to lock onto the faceplate. The probe measures 1m
in length, enough to be put just about anywhere in a full tower case.
LCDs mounted
Click to enlarge |
Rear view
Click to enlarge |
There you have it! You're now ready to mount it on
your case front bezel and start to monitor your CPU or graphics card
temperatures! Lemme know
if this guide has helped you in anyway!
<< Page
1 | Back to VH Frontpage >>
