But now, where do we connect them to? There are a few common inputs:

CDIN(2)(3..) - Obviously for your CD-ROM(s) :)
Aux(2)(3..) - Extra misc. inputs
MIC - Microphone in
TAD - For modems that don't have an onboard speaker, or used for voice capabilities

NOTE: The MIC and TAD inputs are almost always MONO (one channel only)! Only use these if you have a mono source (I have an old FM tuner connected to TAD)

Last thing you need to do is cut a hole in the back if your case so you can mount the inputs. I didn't have any decent cutting wheels handy, so I just drilled it out. Doesn't look all that great, but works nonetheless (besides you only see it from the inside)

Back of the case

Connected to the Live!

Digital Inputs
More and more cards nowadays include some sort of digital (SPDIF) input. This lets you deliver crystal clear sound from any source that supports it. Most CD-ROMS also have the 2-wire SPDIF output. You can use an SPDIF cable instead of a CD-ROM cable to get better sound from your CD-ROM, but you can also create an adapter to use an external source, like a stereo receiver.

2 wires:

Red: Data
Black: Ground

Unlike an analog input, SPDIF only requires one RCA jack, since all channels run off just one wire. For this mod we'll include one analog input along with the digital one.

What we'll need:

• 3 Shielded Phono Jacks (Radio Shack #274-346)
• 2-wire connector (eg from case lights or switches, or SPDIF cable)
• 4-wire CD-ROM audio cable

Step 1: Measure and drill out a few 1/4" holes. We're going to have an analog and digital input here, so we need 3 holes:

Step 2: Next, mount the RCA jacks in the holes (makes it easier when soldering)

Our bracket w/RCA Jacks

Back of the bracket

Step 3: Once you've got the 2-pin cable cut and stripped, solder the (non white or black) wire to the outside pole (again, ground). Then solder the other colour to the center pole. I bent the ground pole 45 degrees for a little more clearance when we install the bracket:

Step 4: Create a analog input using the last 2 jacks (check page 1 for details)

Here we go, an external digital input, with an analog one to boot:

Now all we have to do is connect it to our sound card:

Bracket installed

And connected to the Live!

That wraps up this guide. These mods may not be the most innovative on the planet, but it adds a few more features to your 'puter without breaking the bank.

Enjoy!

Cheers
The Doc

<< Page 1 | Back to VH Frontpage >>

 

Got News? Send 'em in!