ETCHED WINDOW APPLIQUE KIT
INSTALLATION INSTRUCTIONS
www.pcmods.com

Thank you for purchasing the PcMods etched window applique kit.

PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLING.

1. Clean window completely using an acrylic-friendly cleanser. Most window cleaners and products containing ammonia are NOT acrylic-frindly! Pcods recommends using soap and water for this process

2. Dry the window. Make sure the there is no soap left on it.

3. Spray a fine mist of water over the surface of the window.

4. Remove the opaque white backin from the translucent backing. Make sure that the sticker stays on the translucent backing.

5. Carefully apply the sticker to the acrylic pane.

6. Remove the translucent backing from the sticker.

7. Using squeegee remove any air bubbles, working out from the center. Any trapped bubbles can be left for step 9.

8. Wait 24 hours. You will notice that the etched effect improves as the adhesive dries.

9. After the 24 hours has passed, look for air bubbles. Using a needle, poke a hole in the middle of each air bubble Squeeze the air bubble out through the hole.

If you wish to remoce your applique, carefully strip it off and wash the window as necessary.

PcMods.com is not responsible for damage to equipment caused by incorrect or poorly executed installations.